Home / Shop by part type / Wide Angle (C.V.) Shafts / WE35150
53 HP Wide Angle CV Shaft, Standard End Yoke — 1 3/8" x 6 tractor end, 70"–109"
WE35150 · W2480 series · Wide Angle CV Shaft, Standard End Yoke
$990
Specification
- Product family
- Wide Angle (C.V.) Shafts
- Series
- W2480
- Position
- Tractor to baler
- End yoke
- Standard non wide angle end yoke
- Tractor spline
- 1 3/8" x 6
- Closed, cross to cross
- 63" (160 cm)
- Open, cross to cross
- 102" (259 cm)
- Closed length (collapsed)
- 70" (178 cm)
- Open length (extended)
- 109" (277 cm)
- Power at 540 rpm
- 53 hp
- Power at 1000 rpm
- 83 hp
- Decoded
- Wide angle, bare implement end
Match the tractor, not the implement. The shaft’s rating must meet or exceed your tractor’s PTO horsepower. Undersize it and the driveline becomes the part that fails.
Check your PTO speed. This shaft is rated 53 hp at 540 rpm and 83 hp at 1000 rpm. Use the figure for the speed you actually run — they are not interchangeable.
Working it hard? Bare Co advise reducing the rated horsepower by 40% for severe conditions — shock loading, heavy or wet crop, stony ground.
Length
Closed is the shaft fully collapsed — its shortest. Open is fully extended — its longest. Your tractor and implement must sit inside that range at every point through the turn.
Cross to cross is measured between the centres of the two universal joints. Overall is the full length including the end yokes. Most machine specs quote cross to cross.
This shaft trims to length. Measure your machine at its shortest point — the shaft must not bottom out — then cut to suit. You can always take metal off; you cannot put it back.
Listed as WE35150 SHAFT + A035138 YOKE = 35.10.142
FITS THESE MACHINES
| Machine | Position | Tier |
|---|---|---|
| Vermeer 504M | Tractor to baler | Standard |
| Vermeer 604M | Tractor to baler | Standard |
| Vermeer 605M | Tractor to baler | Standard |