Home / Shop by part type / Wide Angle (C.V.) Shafts / OHE36150

110 HP Half Shaft, Implement End, Less Yoke — shaft less end yoke, 66"–105"

OHE36150 · W2580 series · Half Shaft, Implement End, Less Yoke

$292

This is one half of a driveline. A implement end (outer drive tube) on its own will not drive the implement — you also need the matching tractor end in the same W2580 series. The options are listed below.

Specification

Product family: Wide Angle (C.V.) Shafts
Series: W2580
Tier: Standard
Position: Implement end (outer drive tube)
End yoke: Shaft less end yoke
Cross journal diameter: 32/36 mm (1.26/1.42")
Cross length: 89/106 mm (3.50/4.17")
Closed, cross to cross: 51" (130 cm)
Open, cross to cross: 83" (211 cm)
Closed length (collapsed): 66" (168 cm)
Open length (extended): 105" (267 cm)
Power at 540 rpm: 110 hp
Power at 1000 rpm: 170 hp
Decoded: Half shaft less end yoke

Match the tractor, not the implement. The shaft’s rating must meet or exceed your tractor’s PTO horsepower. Undersize it and the driveline becomes the part that fails.

Check your PTO speed. This shaft is rated 110 hp at 540 rpm and 170 hp at 1000 rpm. Use the figure for the speed you actually run — they are not interchangeable.

Working it hard? Bare Co advise reducing the rated horsepower by 40% for severe conditions — shock loading, heavy or wet crop, stony ground.

Length

Closed is the shaft fully collapsed — its shortest. Open is fully extended — its longest. Your tractor and implement must sit inside that range at every point through the turn.

Cross to cross is measured between the centres of the two universal joints. Overall is the full length including the end yokes. Most machine specs quote cross to cross.

This shaft trims to length. Measure your machine at its shortest point — the shaft must not bottom out — then cut to suit. You can always take metal off; you cannot put it back.

Bare shaft; order special end yoke, shear bolt yoke or clutch separately

COMPLETES THIS DRIVELINE